What the QHY533 M Combo Includes
The QHY533 M combo kit bundles the QHY533M monochrome camera with a CFW3S-SR filter wheel and an OAG-S off-axis guider. This is a complete imaging train for astrophotography, but assembly requires attention to spacing and alignment. This guide walks you through the supported steps using the supplied specifications.
Key Specs That Affect Setup
- QHY533 M + Filter Wheel + OAG Combo Kit: Combined with the CFW, the actual back focus consumed is 14 mm; the standard back focal length is 17.5mm (±0.5). This tells you how much spacing the filter wheel adds, so you can plan the rest of your imaging train to reach the correct sensor distance.

QHY533 M + Filter Wheel + OAG Combo Kit - QHY533 M + Filter Wheel + OAG Combo Kit: The filter wheel supports 7 positions for 1.25-inch mounted or 31mm unmounted filters. Choose the right filter size for your setup; 1.25-inch mounted filters are common, but unmounted 31mm filters offer a thinner profile.
- QHY533 M + Filter Wheel + OAG Combo Kit: The OAG is suitable for CCD/CMOS sensors 1 inch or smaller, with an M42/0.75 thread and 6 x M3 screw hole positions. Confirm your guide camera and main camera fit within these constraints before ordering; the OAG is not designed for larger sensors.
Step-by-Step First-Light Assembly
Follow these steps in order to assemble the QHY533 M combo correctly. The supplied specifications confirm the connections and spacing, but you should verify compatibility with your telescope and guide camera before starting.
- Mount the filter wheel to the camera: Attach the CFW3S-SR filter wheel to the QHY533M camera body. The combined back focus consumed is 14 mm, so no additional spacer is needed between these two components.
- Install your filters: Place your 1.25-inch mounted or 31mm unmounted filters into the 7-position wheel. Ensure each filter is seated properly to avoid vignetting or tilt.
- Attach the OAG: Connect the OAG-S to the filter wheel using the M42/0.75 thread. The OAG is designed for sensors 1 inch or smaller, so verify your guide camera fits within this limit.
- Connect to your telescope: Use the 6 x M3 screw holes on the OAG to attach the entire assembly to your telescope's focuser or reducer. Ensure the connection is secure but not over-tightened.
- Align the guide camera: Rotate the OAG to position the guide camera's prism in the light path. Adjust until you see stars in the guide camera's field of view, then lock the rotation.
- Check back focus: Measure the total back focus from the telescope's rear thread to the camera sensor. The standard requirement is 17.5mm (±0.5) when using the filter wheel; add spacers if needed.
OAG Alignment Tips
Aligning the off-axis guider is the most common challenge for beginners. The OAG-S uses a small prism that intercepts light from the edge of the field. To get a usable guide star, rotate the OAG until the prism is in a star-rich area, then focus the guide camera independently. The supplied specifications confirm the OAG is suitable for sensors 1 inch or smaller, so your guide camera must fit that size.
What the Catalog Does Not Confirm
The supplied information does not include detailed operating instructions for the camera, filter wheel, or OAG, nor does it specify power requirements, USB connections, or software setup. For those steps, refer to the individual product pages or the manufacturer's documentation. Also, the catalog does not confirm interoperability with specific telescopes or guide cameras beyond the sensor size and thread specifications.

