Why 36mm LRGB Filters for Mono Imaging?
When you switch from a one-shot-color camera to a mono astronomy camera, you gain control over each color channel. LRGB (Luminance, Red, Green, Blue) filters let you capture separate frames for each channel and combine them later for a full-color image. The ZWO 36mm LRGB filter set is designed specifically for this workflow, with coatings and bandpasses that keep color separation clean and minimize light pollution effects.
ZWO 36mm LRGB Filter Set Key Specifications
- 36mm LRGB Filters: The set includes four 36mm filters (L, R, G, B) with a thickness of 2mm. The 36mm size fits most filter wheels and camera bays. The 2mm thickness means you likely won't need to refocus when switching filters, saving time during an imaging session.

36mm LRGB Filters - 36mm LRGB Filters: Band passes combine to weights approximately 1:1:1, with a small gap between green and red bands to reduce common light pollution. Balanced channel weights simplify color calibration later. The intentional gap helps reject skyglow from artificial lighting, giving you cleaner raw data.
- 36mm LRGB Filters: The red filter cuts infrared wavelengths. IR-cut in the red channel prevents bloated stars and false color from IR leakage, a common issue when using uncooled or older cameras.
Installing 36mm LRGB Filters in Your Wheel
These instructions are based on the supplied filter orientation method. Always check your own filter wheel's manual for specific threading and spacing requirements.
- Check the filter orientation: Lay the filter flat on a clean surface. If you can see two shadows of the filter edge, that side should face the telescope. If you see one shadow, that side should face the sensor. This ensures the coating orientation is correct for your optical path.
- Hold the filter by the edges: Hold a pen over the top of the filter (not touching) to avoid fingerprints. Screw the filter into the wheel cell gently – do not overtighten.
- Install each filter in its own slot: Label the slots or use the wheel's software to assign L, R, G, B to the correct positions. A typical order is L, R, G, B, but any consistent order works as long as your capture software matches.
- Test focus: Because these filters are only 2mm thick, you should need minimal or no refocusing between filters. Take a short test exposure on a bright star to confirm focus consistency.
What the Supplied Information Doesn't Cover
The product record confirms the filter size, thickness, and bandpass design, but does not specify exact transmission percentages, anti-reflection coating details, or recommended exposure times. For exposure guidance, start with your camera's gain and offset settings and adjust based on histogram peaks for each channel. The supplied orientation method is specific to these ZWO filters – if you use another brand, check their instructions.

